CCNP(R&S)


ROUTE 300-101

Enhanced Interior Gateway Routing Protocol (EIGRP)

  • EIGRP Neighbour Adjacencies
  • EIGRP Neighbour over WAN
  • EIGRP Topology, Routes and Convergence
  • Building EIGRP Topology table
  • Building IP Routing table
  • Optimizing EIGRP convergence
  • EIGRP Route Summarization and Filtering
  • Route Filtering
  • Route Summarization
  • Default Routes

Open Shortest Path First (OSPF)

  • OSPF Overview and Neighbour Adjaceny
  • OSPF link state concept
  • OSPF neighbours and Adjacencies on LANs
  • OSPF neighbours and Adjacencies on WANs
  • OSPF Topology, Routes and Convergence
  • LSAs and the OSPF Link state database
  • The database exchange process
  • Choosing best OSPF Routes
  • Route Summarization, default routing, Filtering and Virtual Links in OSPF
  • Route Filtering
  • Route Summarization
  • Default Routes
  • Stub Areas
  • Virtual Links

Path Control

  • Route redistribution
  • Redistribution into EIGRP
  • Redistribution into OSPF
  • Redistribution with route map and distribute lists
  • Problems with multiple Redistribution Points
  • Policy based Routing
  • IP service-level Agreement

Border Gateway Protocol (BGP)

  • The fundamentals of Internet Routing and Addressing
  • Introduction to BGP
  • Outward Routing toward the Internet
  • External BGP for Enterprises
  • Verifying the BGP table
  • Injecting Routes into BGP
  • Internal BGP between Internetwork Connected Routers
  • Routing Loops Avoidance
  • Filtering Routes and Clearing BGP peers
  • Best Path Algorithm and BGP path attributes
  • Influencing an enterprise’s inbound and outbound Routes

IP version 6

  • Global Unicast Address Assigning, Routing, and Subnetting
  • Assigning IPv6 Global Unicast Addresses
  • Configuring IP version 6 addresses on Cisco Routers
  • RIP Next Generation (Ring)
  • EIGRP for IPv6
  • OSPF version 3
  • IPv6 IGP Redistribution
  • IP Migration from IPv4 to IPv6 and coexistence concepts
  • Static Point-to-Point IPv6 tunnels
  • Dynamic Multipoint IPv6 Tunnels

 

 

TSHOOT 300-135

Network Maintenance Overview

  • Understanding Maintenance methods
  • Common Maintenance Methods
  • Tools for Network Maintenance

Troubleshooting Procedures Overview

  • Methods used for troubleshooting
  • Following Troubleshooting Procedures
  • Troubleshooting during Routine Network maintenance

Maintenance and Troubleshooting Tool box

  • Cisco Diagnostic Tools
  • Performing packet captures
  • Creating baseline with SNMP and Netflow

Basic Switch troubleshooting

  • Troubleshooting VLANs
  • Troubleshooting STP
  • Resolving InterVLAN Routing issues
  • Router Redundancy Troubleshooting
  • Switch performance troubleshooting

Troubleshooting Routing Protocols

  • Layer 3 troubleshooting
  • Troubleshooting EIGRP
  • Troubleshooting EIGRP
  • Redistribution Troubleshooting
  • BGP troubleshooting issues
  • Issues with Router performance

IP services Troubleshooting

  • Troubleshooting NAT
  • Troubleshooting DHCP
  • Troubleshooting Network services


 IPv6 troubleshooting

  • OSPFv3 troubleshooting
  • RIPng troubleshooting

SWITCH 300-115

Operation of Layer 2 Switch

  • Multilayer Switch Operation
  • Switch Tables
  • Monitoring SwitchTables
  • Configuring Switchports
  • Ethernet Concepts
  • Connecting Switches and Devices
  • Switch Port Configuration

Implement a Security Extension of a Layer 2 solution, given a network design and a set of requirements

  • Determine network resources needed for implementing a Security solution
  • Create a implementation plan for the Security solution
  • Create a verification plan for the Security solution
  • Configure port security features
  • Configure general switch security features
  • Configure private VLANs Configure VACL and PACL
  • Verify the Security based solution was implemented properly using show and debug commands
  • Document results of Security implementation and verification

Virtual LANs and Trunks

  • Virtual LANs
  • VLAN Trunks configurations
  • Troubleshooting VLANs and Trunks
  • VLAN Trunking Protocol
  • VTP configuration
  • VTP pruning
  • Troubleshooting VTP

Aggregating Switch Links

  • Ether Channel
  • Etherchannel Negotiation Protocols
  • Etherchannel Configuration
  • Troubleshooting an EtherChannel

Spanning Tree Protocol (STP)

  • Tradition Spanning Tree Protocol
  • IEEE 802.1D
  • Types of STP
  • STP Configuration
  • Tuning Spanning-Tree Convergence
  • Redundant Link Convergence
  • Monitoring STP
  • Protecting the STP Topology
  • Unexpected BPDUs
  • Against Sudden Loss of BPDUs
  • Filtering BPDU to Disable STP on a port
  • Advanced Spanning Tree Protocol
  • Rapid Spanning Tree Protocol (RSTP)
  • Multiple Spanning Tree Protocol(MST)

Multi Layer Switching

  • Inter VLAN Routing
  • Multilayer Switching with CEF
  • Verifying Multilayer Switching
  • Using DHCP with a Multilayer Switch
  • Enterprise Campus Network Design
  • Hierarchical Network Design
  • Modular Network Design

Layer 3 high Availability

  • Layer 3 Redundancy in Multilayer switching
  • Route processor Redundancy
  • Securing with VLANs
  • VLAN Access Lists
  • Private VLANs
  • Securing VLAN Trunks

 

 



COURSE SCHEDULE
Duration : 1 Month
Batches : Every month 15th and 30th
Timings
  : Morning ( 7:30 a.m to 9:30 a.m),Afternoon (2:00 p.m to 4:00 p.m) & Evening (7:30 p.m to 9:30 p.m)

Classes are from Monday to Saturday

Labs are opened on sunday also

Fees: 4500 +18% Service Tax


Note:We provide FASTTRACK & ONLINE classes also